Permatex® Anaerobic Gasket Maker (6ml)

Permatex Anaerobic Gasket Maker is a noncorrosive gasketing material designed primarily for use on aluminum, iron, and steel flanged mating surfaces. Ideal for on-the-spot and emergency repairs, or when a conventional gasket is unavailable. Fills gaps up to .015″ (0.381mm) and cures to a solvent-resistant seal that will not tear or decay during service. Parts disassemble easily even after extended service.

Features

1. Ideal for on-the-spot and emergency repairs, or when a conventional gasket is unavailable
2. Fills gaps to .015" (0.381mm)
3. Cures to a solvent-resistant seal that will not tear or decay during service
4. Parts disassemble easily even after extended service
5. Old gasket material can be removed in minutes with a putty knife

To make a gasket:

1. Clean both flange surfaces. Remove paint, dirt, grease or old gasket completely.
2. Spray Permatex Surface Prep® activator on one surface only. Allow to dry 1-2 minutes.
3. Apply a continuous bead of sealant to the unprimed surface.
4. Assemble mating surfaces with minimal lateral movement.

Excess sealant can be wiped away with a cloth and shop solvent.

To dress a gasket:

1. Clean both flange surfaces. Remove paint, dirt, grease or old gasket completely
2. Spray Permatex Surface Prep® activator to both flange surfaces. Allow to dry 1-2 minutes
3. Completely cover both sides of the precut gasket with sealant
4. Place coated gasket on flange and assemble mating surfaces with minimal lateral movement.

Documents

• SDS Sheet
• TDS Sheet